Dot to dot - the hole story

Step 1:Wrap the under layer (the green paper on my package). You do not need to wrap the entire package, you can wrap it just to the point where the top layer will overlap by approximately 1-1/2 inches or so (depends upon how big your paper punch is).



Step 2:Fit the top layer over the bottom layer,making sure that you have ample overlap for your paper punch design. DO NOT tape it into place, but make plenty of crisp edges so it will be easy to fit it into place later.



Step 3:Remove the top layer and punch your designs onto the edge of the paper that will be on the top of the package and will overlap the bottom layer.



Save the designs that you punch out and set them aside for use a little later.



Step 4:Now fit the top layer into place. Secure with tape under the package and on the side.



Step 5:Align the dots as you like and secure with a bit of glue.